Page 15: Transmitter Set-Up Procedures Transmitter Set-Up Procedures *When making these settings adjustments, do so with the motor disconnected or the engine not running. (Preparations) Select the model memory that is not used and reset it to the initial values with the model selection and model reset functions. Model Selection Model Reset Push
Go to the Link, Function menu. Change throttle (THR) to Motor (MOT). That will automatically give you a safety switch. Go to the Model Menu (MDL button). On the 2nd page you will have a new menu called MOTOR. MOTOR menu allows you to set a safety switch and OFF value. Use only the Futaba lithium ion transmitter charger included with this set for, or other chargers approved by Futaba to charge the Li-Ion batteries in the 14MZ transmitter. Page 8 AT THE FLYING FIELD Always pay particular attention to the flying fields’ rules, as well as the presence and location of spectators, the wind direction, and any Reflex V2 setup. Setting up my Zero Using a Hitec 6ch receiver so weitg the flaps and gear I have no spare channel for the gyro mode switch. The instructions state for a four-channel transmitter you can use an included jumper, which is not included, to plug it into the "gyro mode input" to switch it to optimize mode as default.This is the Align Trex 150 DFC Combo Setup/Binding Procedure for Futaba FHSS. The radio used is the 14 SG. In this video you will find the programming and se
TAWAN-REVIEW: How to set 2 servo for Elevator, P.Mix by Futaba T10J#P_Mix #Futaba_T10J#TawanReview
. 467 430 64 22 0 156 486 885